Previous Thread
I have a linksys E4200 Gigabit router+Wireless-N AP, the pogoplug v4 is conected to it over 1Gbps without any problems.
Categories: Pogoplug Mobile & Series 4
January 11, 2012 5:15 AM
January 18, 2012 8:32 AM
having same problem. only getting 10mbps on pogoplug. other connected devices getting a gig connection.
January 20, 2012 6:05 PM
Yes, same issues. But to be exact, it is in the properties of the pogo connection that it shows up as a lowly 10Mb/s. My router shows all connections as gigabit. One tech told me the issue was because I had a high end router (Cisco).
Also, if I was getting 10Mb/s transfers, that would be five times faster than what I'm seeing.
I'm guessing it is bad software drivers for the pogo interface.
Add Your Reply
Copyright © 2012
Capable Networks LLC.. All Rights Reserved.
RSS |
Privacy Policy |
Advertise With Us |
Terms of Use |
About Us |
Contact Us |
Site Map
Our Capable Community Network:
DVR playground |
Explore3DTV |
MediaSmart Home |
MotoDash |
My Open Router |
Pogoplugged |
DijitCommunity |
Robo Community |
Sansa Community |
TechLore |
TiVo Community |
TouchSmartDevZone
Pogoplug™ is a trademark of CloudEngines, Inc. PogoPlugged.com is not affiliated with CloudEngines, Inc.
The Pogoplug 4 is plugged into a gigabit router. When I look at my networks, I see my internet line which is 1 Gbps, and the Pogoplug which says is at 10Mbps. Why is this? I tried a different port, but still says the same speed.