Previous Thread
If it were a dockstar, it was stxadmin, pogoplugs had ceadmin. You're better off using the my.pogoplug.com to set it, if possible.
This contains some information on what the original information may have been: https://forum.openwrt.org/viewtopic.php?id=28728 but be warned that (I certainly can't verify) editing these files with the values show may not be ceadmin or stxadmin.
Categories: Pogoplug Classic
I am encountering the following when I SSH into my Pogoplug:
Pogoplug:~$ passwd
Changing password for root
New password:
Bad password: too weak
Retype password:
passwd: cannot update password file /etc/shadow
Pogoplug:~$
=============
Can anyone advise on how to change the password back to the default password, in this case, 'stxadmin'?
August 31, 2011 2:21 PM
August 31, 2011 5:08 PM
WarheadsSE,
Thank you for your reply.
Unfortunately, once the SSH access is enabled through my.pogogplug.com (with the current web interface as of 08.31.11), the user is prompted for a password. I do not believe it can be changed from that point forward once it has been set; I am not 100% on that point, however. Will need to double check.
August 31, 2011 5:08 PM
By the way, I am a bit confused on the information provided at the link you shared. Sorry, my UNIX knowledge is a bit minimal.
Add Your Reply
Copyright © 2012
Capable Networks LLC.. All Rights Reserved.
RSS |
Privacy Policy |
Advertise With Us |
Terms of Use |
About Us |
Contact Us |
Site Map
Our Capable Community Network:
DVR playground |
Explore3DTV |
MediaSmart Home |
MotoDash |
My Open Router |
Pogoplugged |
DijitCommunity |
Robo Community |
Sansa Community |
TechLore |
TiVo Community |
TouchSmartDevZone
Pogoplug™ is a trademark of CloudEngines, Inc. PogoPlugged.com is not affiliated with CloudEngines, Inc.
Bump.