http://www.ctrlaltdeleted.co..."/>
OUR NETWORK:TiVoCommunity TechLore MyOpenRouter Dijit Community MediaSmart Home See all... About UsAdvertiseContact Us
Previous Thread | Next Thread

 
Learn about scoring Forum's Raw Score: 171893.0
August 19, 2011 05:41 AM

Categories: PogoPlug Development

Rating (0 votes)
  • 1
  • 2
  • 3
  • 4
  • 5
Rate This!

Member Avatar

Jeff D

Member
Joined: 08/19/2011

Hello All- a friend and I are attempting to get SAMBA installed so that we can access our movies and music on an Apple TV. We are both trying to follow the following: http://www.ctrlaltdeleted.com/?p=3

However, it doesn't seem to be working. We get stuck at the step wget http://ipkg.nslu2-linux.org/feeds/optware/cs08q1armel/cross/unstable/ipkg-opt...


We keep getting the following error when trying to run that command: Connecting to ipkg.nslu2-linux.org (140.211.169.161:80)wget: server returned error: HTTP/1.1 404 Not Found

Please help! Thanks in advance!

Jeff 

Discussion:    Add a Comment | Comments 1-3 of 3 | Latest Comment

Generic Member Avatar
Member
August 24, 2011 10:46 AM

Your link:
"http://ipkg.nslu2-linux.org/feeds/optware/cs08q1armel/cross/unstable/ipkg-opt_0.99.163-10_arm.ipk%3C/span%3E%3C/p%3E"

Correct link:
http://ipkg.nslu2-linux.org/feeds/optware/cs08q1armel/cross/unstable/ipkg-opt...

Generic Member Avatar
Member
September 1, 2011 12:59 PM

Thanks, that worked! I am now getting stuck on this step:

# set it up
tar -xOvzf ipkg-opt_*_arm.ipk ./data.tar.gz | tar -C / -xzvf -
mkdir -p /opt/etc/ipkg
echo "src cross http://ipkg.nslu2-linux.org/feeds/optware/cs08q1armel/cross/uns
table" > /opt/etc/ipkg/armel-feed.conf
echo "src native http://ipkg.nslu2-linux.org/feeds/optware/cs08q1armel/native/u
nstable" >> /opt/etc/ipkg/armel-feed.conf

Any suggestions?

Generic Member Avatar
Member
  • member since: 09/27/2011
  • rank: 4143 of 13233
  • 2 comments
September 29, 2011 2:21 PM

Jeff, I was running into the same issues. I found that merging the two sets of instructions worked for me.

I would run through one and get stuck, then run through another and get stuck, so i kinda did them side by side and everything is installed as it should.

The issue i am encountering now is just how to configure the smb.conf file as i am on a mac and my network settings are different with a time capsule than a regular netgear/cisco router...

http://www.nslu2-linux.org/wiki/Main/PlugComputers

and.....

http://www.ctrlaltdeleted.com/?p=3

Discussion:    Add a Comment | Comments 1-3 of 3 | Latest Comment

Add Your Reply

(will not be displayed)

Email me when comments are added to this thread

 
 

Please log in or register to participate in this community!

Log In

Remember

Not a member? Sign up!

Did you forget your password?

You can also log in using OpenID.

close this window
close this window