Are you considering the ethernet-activity LEDs, on the back of the Pogoplug, to be the blinking-amber & solid-green lights? The light support would be asking about is the Pogoplug logo on the front of the device. If that light is solid-green(after about 1min), you're usually all set.

Please describe your setup and chances are we'll be able to bring you to resolution in short-order.

Thanks,

The only limit to the Pogoplug is your imagination... and C skills... and linux skills. ^_^ h\t\tp://download.pogoplug.com/opensource/pogoplug-gcc.tar.bz2

I have the same issue. On the back of the pogoplug (at the ethernet connection), I have a solid green light and a blinking amber light. I am now getting a message that "Bad drive letter".

Hello all,

We all need to stop looking at the ethernet-port lights. Yes, there is one that is solid green and one that is blinking amber. Those small, square lights are suppose to do that.

The real indicator is the ***front*** of the Pogoplug. The Pogoplug logo, blinks green on start up... then after about 2mins, will be only one of the following:

- Solid green = Should be working okay
- Solid amber = Problem. Something about the network is preventing communication. It could also mean there is a problem with 1 or more of the drives connected to it.

The only limit to the Pogoplug is your imagination... and C skills... and linux skills. ^_^ h\t\tp://download.pogoplug.com/opensource/pogoplug-gcc.tar.bz2

i have same thing solid green and flashing amber.was fully refunded.was told to replace the battery as its not holding charge.item is all show,concept good but this is a trial and error at present