Previous Thread
Which device?
You'll likely need to verify that the hbwd is properly launched from hbmgr.sh
Categories: PogoPlug Development
After several failed attempts to install a different Linux on a thumb drive, I am trying to go back to normal pogoplug functionality. It seems to boot okay an I can see the device from the website, but any drives attached don't show up in the website. When I SSH into the device I can:
1) Mount the attached drive manually (in terminal only)
2) List running processes an hbwd is not among them
How can I get hbwd running again? Or is that not the problem?
Breaking the Corporate Juggernaut - ProvideYourOwn.com
April 28, 2011 10:44 AM
April 28, 2011 4:24 PM
/etc/init.d/hbmgr.sh start
Should be in your /etc/init.d/rcS somewhere toward the end.
April 28, 2011 4:26 PM
/etc/init.d/hbmgr.sh
Also, it may be that the line that fires up hbwd inside this script is disabled. Thanks for recalling the script name OddballHero
April 28, 2011 4:34 PM
WarheadsSE said: /etc/init.d/hbmgr.sh Also, it may be that the line that fires up hbwd inside this script is disabled. Thanks for recalling the script name OddballHeroYou might want to fix the links on your website. Some of them, like the ones for the original rcS scripts, are dead.
April 28, 2011 4:44 PM
From what I read here:
http://plugapps.com/forum/viewtopic.php?f=18&t=1058#p6099
You were trying to load Debian on a V2 Pinky. Should not have had too much of a problem.
Did you already post on http://forum.doozan.com/ ?
Add Your Reply
Copyright © 2012
Capable Networks LLC.. All Rights Reserved.
RSS |
Privacy Policy |
Advertise With Us |
Terms of Use |
About Us |
Contact Us |
Site Map
Our Capable Community Network:
DVR playground |
Explore3DTV |
MediaSmart Home |
MotoDash |
My Open Router |
Pogoplugged |
DijitCommunity |
Robo Community |
Sansa Community |
TechLore |
TiVo Community |
TouchSmartDevZone
Pogoplug™ is a trademark of CloudEngines, Inc. PogoPlugged.com is not affiliated with CloudEngines, Inc.
