Previous Thread
This might be something with the hard drive you have attached. For example, I have a Maxtor OneTouch attached to my Pogoplug, which "sleeps" after a certain period of time. There is a short delay when trying to access it initially, but then it spins up and is fine.
Try another drive, or even a flash drive, and see if you have similiar issues. If so, contact Pogoplug support and have them check it out.
Categories: Hard Drives / Storage
My Pogoplug drive appears to go into hibernation, so is no longer available.
How do I get the drive out of hibernation or remotely reboot my Pogoplug?
Mike
Editor
- member since: 04/21/2009
- rank: 3 of 13231
- 43 articles authored
- 76 forum threads started
- 615 comments
November 17, 2010 1:08 PM
November 18, 2010 3:04 AM
Thanks for that but the drive can't be used no matter how long I wait, also Pogoplug says the drive is not available but ir will let me eject it.
The only way to make the drive available is to switch off the Pogoplug, disconnect the drive, power up Pogoplug & wait for green light then connect external drive. This means that I can't re-enasble drive remotely.
The only way that I can make drive available for any length of time is to remove all the thumbnails etc., so Pogoplug is busy recreating them so drive does not hibernate.
Add Your Reply
Copyright © 2012
Capable Networks LLC.. All Rights Reserved.
RSS |
Privacy Policy |
Advertise With Us |
Terms of Use |
About Us |
Contact Us |
Site Map
Our Capable Community Network:
DVR playground |
Explore3DTV |
MediaSmart Home |
MotoDash |
My Open Router |
Pogoplugged |
DijitCommunity |
Robo Community |
Sansa Community |
TechLore |
TiVo Community |
TouchSmartDevZone
Pogoplug™ is a trademark of CloudEngines, Inc. PogoPlugged.com is not affiliated with CloudEngines, Inc.
